Inland Empire (Riverside & San Bernardino)
Start with a ZIP. TapCheck matches a California public water system, then shows curated detections vs EPA limits and CA health guidelines — not a citywide average and not a faucet lab test.
Want a filter for your water? Get a free quote from a local installer.
Get a free filter quoteExample ZIPs to try
City water guides in this area
How the Inland Empire gets its water
The Inland Empire, western Riverside and San Bernardino counties, runs on two very different kinds of water. Older cities in the valley floor pump local groundwater from basins such as Bunker Hill, Chino, Rialto-Colton, Lytle Creek and Cucamonga, recharged by runoff from the San Bernardino and San Gabriel mountains. Other areas rely on imported water: State Water Project supplies from Northern California and Colorado River water. Metropolitan Water District treats much of it at the Henry J. Mills and Robert A. Skinner plants, and Lake Mathews stores Colorado River water before it reaches cities like Corona.
Which kind reaches your tap shapes almost everything about it. Groundwater cities tend to have harder water and low-level detections of nitrate, chromium 6, arsenic or legacy industrial chemicals. Imported-water areas tend to have softer water with fewer of those, but more disinfection byproducts. Many cities blend both, and the mix changes with drought, maintenance and season.
City-by-city snapshot (2025 utility reports)
Averages from each city's main utility. Units: hardness in mg/L as calcium carbonate, nitrate in mg/L as N, chromium 6 in µg/L. Neighboring districts serve parts of most cities, so open your ZIP report.
| City | Main utility | Main sources | Hardness | Nitrate | Chromium 6 |
|---|---|---|---|---|---|
| Riverside | Riverside Public Utilities | 100% groundwater (Bunker Hill, Riverside basins) | 197 | 5.4 | 2.1 |
| San Bernardino | San Bernardino Municipal Water Dept. | 100% groundwater (Bunker Hill) | 242 | 3.74 | 1.25* |
| Fontana | Fontana Water Company | 73% groundwater, 12% Lytle Creek, 15% State Water Project | 151 (wells) | 4.78 (wells) | 1.4 (wells) |
| Rialto | City of Rialto | ~75% wells, 15% Baseline Feeder, 10% surface | 160 | 2.55 | 1.5 |
| Ontario | Ontario Municipal Utilities Co. | 64.5% city wells, 27.7% purchased groundwater, 7.8% imported | 124 (city wells) | 2.7 (city wells) | 3.9 (city wells) |
| Rancho Cucamonga | Cucamonga Valley Water District | 51% groundwater, 41% State Water Project, 8% canyon/tunnel | 125.5 | 3.30 | 0.43 |
| Corona | City of Corona Utilities | 49.6% Colorado River, 45.5% wells, 4.9% State Water Project | 146 | 2.3 (treated) | 0.2 (treated) |
| Moreno Valley | Eastern MWD (Mills area) | Imported State Water Project via Mills plant | ~87 | 0.8 | ND |
*San Bernardino chromium 6 is from 2023–2024 sampling. Legal limits: nitrate 10 mg/L, chromium 6 10 µg/L. Moreno Valley hardness is converted from EMWD's 5.1 grains per gallon. Temecula and Murrieta are covered on their own city pages.
Water issues that show up across the region
- Hard water. Every groundwater-heavy system we reviewed reports hard or very hard water, led by San Bernardino (242 mg/L) and Riverside (197 mg/L). Moreno Valley's imported supply is the softest, at about 87 mg/L. Hardness is a scale and taste issue, not a health limit. See the hard water guide.
- Nitrate. A legacy of fertilizer, septic systems and former farmland. Riverside averaged 5.4 mg/L and some Fontana wells reached 8.0 mg/L, while Corona's raw wells hit 20 mg/L before reverse osmosis brought the treated average to 2.3. The limit of 10 mg/L protects infants. Read the nitrate guide.
- Chromium 6. Found at low levels in most groundwater systems, highest in Ontario's city wells (3.9 µg/L). California's 10 µg/L limit took effect in 2024, but its Public Health Goal is 0.02 µg/L. See the chromium 6 guide.
- Perchlorate and solvents. Historic aerospace and industrial activity left perchlorate, TCE and PCE in parts of the basins. San Bernardino removes TCE and PCE with granular activated carbon under a federal Superfund cleanup. Rialto treats two wells for perchlorate and keeps other affected wells out of service.
- PFAS. Results vary widely. Corona's raw groundwater had PFOA up to 220 ng/L, but none was detected after treatment. San Bernardino reported PFOA and PFHxS above state notification levels in 12 sources, and Fontana reported no PFAS detections. See the PFAS guide.
- Arsenic and DBCP. Natural arsenic appears in San Bernardino (up to 7.6 µg/L) and Riverside wells. DBCP, a banned soil fumigant, shows up in Rancho Cucamonga (average 17 ppt) and one Ontario desalter zone. Both are under legal limits. See the arsenic guide.
Chlorine or chloramine?
It depends on your supplier. Riverside, San Bernardino, Fontana and Rancho Cucamonga report free chlorine residuals. Corona and EMWD's Mills area, which includes Moreno Valley, use chloramine, and Ontario reports a combined chloramine and free-chlorine residual. Chloramine lasts longer in pipes and forms fewer byproducts, but it must be removed for aquariums and dialysis and doesn't fade in a pitcher. See chlorine vs chloramine taste.
Getting your water tested in the Inland Empire
Utility reports describe water leaving the system. They can't show what your own pipes, fixtures or filters add. If you want a tap test:
- Use a state-accredited lab found through the State Water Board's Environmental Laboratory Accreditation Program.
- Match tests to your supply: nitrate, chromium 6 and hardness for groundwater cities, and lead plus byproducts for imported-water areas. Add lead for any home with plumbing from before 1986.
- Follow the lab's sampling steps, which differ for lead, nitrate and organic chemicals.
- Read your own supplier's report first. Find it on your utility's website or in the State Water Board's Drinking Water Watch.
FAQ
Is Inland Empire tap water safe to drink?
Each major city utility we reviewed, including Riverside, San Bernardino, Fontana, Rialto, Ontario, Rancho Cucamonga, Corona and Eastern MWD for Moreno Valley, reported meeting state and federal standards in its 2025 report. Several detect chromium 6, nitrate or arsenic below legal limits but above California health goals.
Why is Inland Empire water so hard?
Much of the region pumps groundwater from basins such as Bunker Hill and Chino, which picks up calcium and magnesium. San Bernardino averaged 242 mg/L and Riverside 197 mg/L in 2025.
Which Inland Empire cities use imported water?
Moreno Valley relies mainly on State Water Project water from Metropolitan's Mills plant. Corona uses about half Colorado River water, and Rancho Cucamonga about 41% State Water Project water.
Is there chromium 6 in Inland Empire water?
Yes, at low levels in many groundwater systems. Ontario city wells averaged 3.9 µg/L and Riverside 2.1 µg/L, both under California's 10 µg/L limit but above the 0.02 µg/L health goal.
How do I find my exact water supplier?
Check the agency name on your water bill, then open our ZIP report. Many Inland Empire ZIP codes are split between two or more water systems.
Where can I get my water tested in the Inland Empire?
Use a lab accredited through the State Water Board's Environmental Laboratory Accreditation Program (ELAP) and follow its sampling instructions.
Share a sample card
Preview a compact social-style card for an example ZIP, then open the full report. Open share card for 92501 →
Cities · All regions · Contaminant glossary · Methodology
Water guides: All guides · Hard water · PFAS · Chromium 6 · Nitrate · Arsenic · Chlorine taste
Want a filter for your water? Get a free quote from a local installer.
Get a free filter quote